Don't forget to check out our Special offers!

(800) 657 1303

The Difference between GEL and AGM Batteries [Infographic]

GEL vs AGM – Which type of battery should you choose?

GEL and AGM batteries are both considered SLA- sealed lead acid batteries , also known as VRLA-valve regulated lead acid. They are Non Spillable, non-hazardaous, and Maintenance-Free and can be safely used in any position. They can also be transported without special handling.

These two technologies are the two most commonly known on the market, with each having certain distinctions that allow them to perform effectively per the purpose they were designed. There are some who wonder which of these two batteries is the best to use. The answer to that is that there is no unanimous agreement, because each battery is designed to excel in an area in which the other is not, hence their performance will depend on the manner in which they are used.

The AGM Battery

AGM stands for Absorbed Glass Mat. The glass mat technology is used to absorb the battery electrolyte between the lead plates. This allows for less resistance within the battery which in turn provides a higher discharge. AGM batteries are generally less expensive but can have more power capacity compared to the same size GEL batteries. However, this design doesn’t allow the battery to cycle as many times as the GEL.

The AGM type is typically preferred for applications that require high burst of power such as UPS units.

The GEL Battery

GEL batteries, which are also known as gelled electrolyte or gel cell batteries, are specifically designed for a deep discharge/deep cycle. The GEL battery contains a silica type gel that the electrolyte is suspended in. GEL batteries normally cost more but have superior cycle life compared to AGM batteries, due to the GEL like substance, protecting the plates and providing higher internal resistance. However, the disadvantage here is that GEL technology gives off a lower discharge- less power than the AGM.  The price per cycle of the two types are comparable. Another worthy mention is that GEL performs better in slightly higher ambient temperatures.

The GEL type is typically preferred for applications requiring frequent or daily use such as wheelchairs, scooters and other mobility applications.

When talking about GEL batteries there is one issue worth noting. They must be recharged correctly or may suffer premature failure. You must use a charger designed specifically for GEL batteries.

Check out the BatterySharks Infographic about AGM vs Gel Batteries below.

AGM_vs_GEL_progress9_Amble_space_661
If you have questions about which battery is best for you, please contact our Customer Service department at 1 (800) 657-1303 or email us.

Share this Image On Your Site

4 Responses so far.

  1. Steven | PSE Battery warehouse says:

    Nice comparison. There are a lot of differences between these and other battery types. This will help people make the right decision.

  2. Tom says:

    Thanks for nothing the need for the correct type of charger for gel batteries. You may have just saved my “gels” and early recycling. :-)

  3. StevenCN says:

    Good comparison.
    The end captions could have provided additional information about charging voltages and full charge voltage differences.
    The GEL battery optimal charging voltages @ 68º using a temperature sensing automatic charger are between 13.8 and 14.1 (max), with float voltage from 13.5 to 13.7.
    The AGM battery is typically spec’d at 14.4 to 14.6 (max) under the same charging conditions, with float voltages matching the GEL type: 13.5 to 13.7.
    Although the GEL type requires a lower charging voltage, the “resting” voltage (no load, open circuit) 24 hours following a full charge is spec’d slightly higher than the AGM: ?12.85 (GEL) vs, ?12.80 (AGM).

  4. […] approved for air travel. The SLA batteries for wheelchairs can be divided into two types – AGM and GEL. Generally Gel batteries are more suitable for electric wheelchairs, but are also more […]

Leave a Reply to Tom Cancel reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>

%d bloggers like this: